SECOND TERM SCHEME OF WORK FOR BASIC TECHNOLOGY JSS 1 (BASIC 7)

Junior Secondary School Curriculum Basic Technology – Edudelight.com

JSS1 First Term Basic Technology Curriculum

Lagos State Currriculum Basic Technology JSS1 Firt Term

1. Drawing Instruments
2. Board practice and uses of lines in technical drawing
3. Free-hand sketching and scale drawing
4. Woodwork tools I; Tools, measuring, marking out and driving tools
5. Woodwork tools II; Tools for boring, work holding, cutting and planning

6 – 11. Revision

12. Examination

SECOND TERM SCHEME OF WORK FOR BASIC TECHNOLOGY JSS 1 (BASIC 7) – MODIFIED I

Week 1; revision of last terms work

Week 2; types of building

Week 3; uses of building material

Week 4; drawing instrument

Week 5; care of drawing instrument                   

Week6; board practice

Week 7; board practice [lettering]

Week 8; free hand sketching

Week 9; sketching of work shop hand tools

Week 10; work bench fittings

Week 11; revision

Week 12; examination 

SECOND TERM SCHEME OF WORK FOR BASIC TECHNOLOGY JSS 1 (BASIC 7) – MODIFIED II

1. Revision of Last Term’s Work
2. Board Practice: basic board practice: (1) setting drawing paper on the board. (ii) Sharpening pencil to conical point and knife-edge. (iii) using the tee and set squares for drawing boarder lines and horizontal and vertical lines (iv) positioning and drawing the title block. (v).writing(freehand) legible letters and numerals
3. Freehand Sketching : basic freehand techniques of drawing lines, curves, circles, and irregular shapes
4. Scales and Scale Drawing: (a) reading graduation on the metric rule. (b) measuring and comparing given sizes
5. Scales And Scale Drawing(cont’d) :(c) scale drawing: (i) types of scale; full size, 1:1 (ii) reduction scale e.g. 1:5, 1:10, 1:20, 1:100, etc. (iii) enlarged scale, e.g. 2:1, 3:1, etc.
6. Woodwork Hand Tools; (a) Measuring tools; metric rule, inside calipers, outside calipers, pair of dividers, etc. (b) Setting and Marking out tools: try-square, sliding bevel, meter square, pair of compasses, trammels, etc.
7. Woodwork Tools (cont’d) (c) Driving tools; hammer; mallet and screw driver, etc. (d) Boring tools; wood brace’ ratchet brace and bradawl, etc.
8. Woodwork Tools (cont’d) (e) Holding devices; Bench hook, Bench vice, ‘G’ cramp, sash clamp, etc. (f) cutting and pairing tools; rip saw, cross cut saw, tenon saw, bow saw, dovetail saw, jack plane, smoothing plane, spoke shaves, chisels, etc.
9. Concept of Energy and Power; (a) Concept of Energy and power. (b) Definitions: (i) power (ii) energy (iii) units (c) relationship between energy and power
10. Revision
11. Examination.